VR to FPV Goggles

thingiverse

Human: I swapped VR to FPV goggles. All printed VR/FPV goggles look awkward. So, I chose cheap VR goggles for the housing. For the project, these ones fit quite well. Cover with vent holes, it is necessary for cooling electronics. Parts designed for perfect fit. Lens holder snaps into place of original ones. Monitor holder screwed in the original screw holes using same screws. Just cut the central septum, drill a few holes for buttons (if you are planning to use them), one hole for cable and one for receiver. Remember, this lens has a central point. Then you cutting it, make sure it's in the middle. Parts used: Monitor http://www.aliexpress.com/item/New-5-800-480-no-320-240-Car-TFT-LCD-Monitor-Screen-2ch-Video-Wholesale/32335381256.html 32CH RX5832 Receiver http://www.banggood.com/5_8G-600mW-32CH-2s6s-DC-Image-Transmission-RX5832-Receiver-For-Multicopter-FPV-p-985687.html VR Stereoscopic Glasses http://www.aliexpress.com/item/Hot-sale-Head-mounted-3D-Virtual-Reality-VR-Stereoscopic-Glasses-For-3-5-6-Inch-IOS/32603008050.html Full Page Magnifying Sheet Fresnel Lens http://www.ebay.com/itm/XL-Full-Page-Magnifying-Sheet-Fresnel-Lens-3X-Magnification-Magnifier-FE-/231437162057?hash=item35e2bad649:g:ItEAAOSw6aVUooUp Print Settings Rafts: No Supports: No Resolution: 0.2 Infill: 100%