VR Cable Hanger

thingiverse

Wanted an improved way to hang wires (and make it effortless to pull down/set back up!) from the Kiwi Design VR cable pulley system (V1). It should be incredibly easy to use for any cable system. The cable will slip slightly in the event of a really hard pull but after several hours of gameplay I had no unwanted slippage. It's specifically designed to utilize the O-rings that come with the Kiwi system. Small rubber bands can be used, or faucet O-rings from Ace, HDX, Lowes, etc... It holds the cable pretty gently. Spreads the load out over about 25-30mm (30mm total part length) which should help prevent cable damage. You should only need a tiny bit of support for the pegs. I've had no trouble printing the tunnel the cable sits in without supports. Hey scummy Etsy sellers, if you're going to sell this, at least give me a shout out as being the creator.