VOXELAB Tool Box Middle Extrusion + WIDE Ver.

thingiverse

Flip it 90 degrees so its standing up. No supports or brim/raft necessary. edit: added slots to right side, one with drawer stops one without. I added stoppers so that the drawer doesn't fall out when pulled, shown in picture. "(stops)" added to the end of the file name. I heated up a hex key with magnet, and pushed an M3 screw slowly through the plastic in the corner rather than middle as to not be in the way of anything when closing. see picture, blue bracket. as for the inside part, called cajon.stl, I printed that laying down, and had it about -1.9 in the Z below the plate so it prints evenly on the bottom, dont worry about the bottom of that tab being cut off. this is so no supports are needed. I took the Toolbox which is also meant for the Ender, this happens to say Voxelab on it. I added 2020/4040 extrusion mounts so that it will be able to mount at the Y plate carriage extrusion.check pictures. I made it so there should be enough clearance for the tensioner, I think there may be enough space for a T-slot nut to be put on either end so it's a tight fit - no slack.