VOXELAB-Aquila X2 Bolt-on! filament guide (metal dual gear extruder)

thingiverse

Modified to suit my needs as I've upgraded to a (red) all metal dual gear extruder on my Aquila X2 which is higher than the original and other replacements. (~23.95 mm high). Widened the bearing holding area to fit a 608zz bearing with V sleeve over it and spacers on either side, changed the screw size to fit an M4 20mm screw with lock nut. Also raised the bearing holding area to suit the additional height of the extruder. Added spacers for the filament runout sensor to mount with 25mm M3 screws. Printed the guide at 0.2 layer height, 25% infill. Printed the bearing sleeve/ring at 0.1 layer height, 20% infill? (I forget the infill tbh), same with the spacers. You need to print: 1x guide 1x ring 2x spacers Additional hardware: 2x M3 25mm screws 1x M4 20mm screw 1x M4 nut, I used a nylon locking nut. 1x 608zz ball bearing You *may* need a tiny dab of superglue on the inside of the spacers and the ring. Mine were a fraction loose but otherwise fine.