Voxelab Aquila SKR 1.4 (turbo) Mount - top entry

thingiverse

This is a replacement electronics compartment for the SKR 1.4 upgrade to the Voxelab Aquila. There is loads of documents out there on firmware and wiring that will do a far better job of it than me - but it is a bit of piecing together lots of parts of the puzzle to get what works for you. It is top entry instead of bottom entry (like stock Voxelab Aquila), because I hate flipping the printer on its side to get to the mainboard. T.he SKR 1.4 (and turbo) only just fit so wiring is a faff. Also, I use octoprint with a PI contained in another electronics compartment on the other side of the printer (https://www.thingiverse.com/thing:6060056), so I wanted the IO not visible on the front - just the intake fan blowing clean air (around all the cables) over the drivers. There is some hardware - im sure you could re-design to use less, but I already had them laying around so gave a good finish. Board and top plate mounting holes are designed for M3 heat set inserts like this: https://www.amazon.co.uk/Uxcell-a16041800ux0824-Knurled-Threaded-Embedment/dp/B01IYWTCWW/ref=sr_1_25?crid=2T7DI8PL4OCSW&keywords=m3+heat+set&qid=1685367723&sprefix=m3+heat+set%2Caps%2C59&sr=8-25 2 T-nuts needed to join to the alu extrusions - alu extrusion end cap screws are stock. Enjoy