Voxelab Aquila Filament Roller Guide

thingiverse

Thanks to Holspeed for the original files for this, go give him a like on his post!(https://www.thingiverse.com/thing:3052488) the Bearing ring is his original file, i modified the spacer to fit an m5 bolt and the bracket i had to extend to fit the Voxelab Aquila perfectly. this lines up the filament perfectly with the filament feed hole on the extruder. i have not printed this bracket file but i only thinned the mounting area down a bit from the one i did print which is pictured. the holes in the bracket are 5mm. i used the extra m5x25mm(i think) screw to hold the bearing in place. it should be just smaller than the bolt and thread in fine. Let me know if you have any issues, it should fit the bracket and bearing pretty tight Enjoy!