Voxelab Aquila/Ender 3 v2 PSU Cover with cable management

thingiverse

This is a very straight forward remix of the Ender 3 V2 PSU Cover (Mainpower) by demolischen. I added a couple of zip tie anchors, cut out a section for smoother cable routing, and made it overall a little more thin for a faster print. This thing fixes a major design flaw with the voxelab aquila and ender 3 v2. The original PSU shroud completely blocks the vents which allow for airflow inside the PSU, causing the fan to run almost 100% of the time and likely shortening the life of the components. By removing the original shroud and putting this in it's place, you remove the restrictions of the original shroud while maintaining the safety of having the terminals covered. I was able to print this at 100 mm/s on my voxelab aquilla with no supports. V2 adds additional zip tie anchors on the other side of the cable channel, thanks to Izerous for the idea. V3 Beefs up the zip tie anchors even more, but adds a bit more bridging. I've also included a bridge test for v3 if you want to see if your printer can handle it with no supports, or you can just print it with supports. My printer handles it fine, but I have a beefed up cooling system.