Voxelab Aquila BL Touch Mount with Adjustable Height

thingiverse

This is a BL Touch/3D Touch mount for the Voxelab Aquila. It can be adjusted up or down to get an ideal probe height. This means you can set it higher, to get the probe further away from the print, or lower, so the nozzle is further away from the bed when probing. You'll need four m3 bolts and two nuts. to mount this. Your BL Touch kit likely came with these. WARNING: Since the height is adjustable, you must be careful that the probe isn't mounted too high. This could cause the nozzle to run into the bed before the probe can reach the bed. Make sure the probe is lower than your nozzle when it is extended, and higher than the nozzle when retracted. Since this is adjustable, there's no definitive Z-offset. You must figure out your own z-offset. I recommend printing at 100% infill for strength. You don't need supports. It should load into your slicer at the correct orientation. But if it doesn't, orient it so the face that goes against the hotend plate is at the bottom.