Voxelab Aquila bed leveling test will work with any 220x220 print bed

thingiverse

Easy bed leveling print. Very quick print. This will help getting the bed level for the full print bed leaving room for the bed clips. Print at 0.2mm layer hight and 0.4mm line width. I suggest printing at 50mm/s or slower! To get the best from this test I suggest you run your finger over the lines just after they start printing. If the lines lift at all just adjust the bed leveling knobs as the print continues! If the lines don't lay down and stick adjust the leveling knobs to the left to raise the bed until the lines stick. If you can get the text in the middle to stick with all the outer perimeter lines you have a very good leveled and flat bed. Be careful not to burn your fingers when live leveling the bed when using this test especially if you run the buld plate at very hight temps! Its common for build plates to be a little low in the middle so don't worry too much if you can't get the text to print or stick! You should come and join my Facebook group "Voxelab Aquila 3D Printing Community" support group link below! https://www.facebook.com/groups/232676078315665 If you want to buy me a coffee as a thank you. https://www.Paypal.me/arnookie