Voron V0 tiny recirculating carbon filter, MFNano Remix

prusaprinters

I was looking for a recirculating carbon filter for my Voron v0.2 printer but encountered some limitations with the Nevermore solution due to space constraints. Instead, I found the MFNano project by MappleLeafMakers, which seemed like a perfect fit with a few modifications. The following are the goals I was striving to achieve.Reuse fans from the StealthBurner project: Since I already had fans from a previous project, and decided to repurpose them for my carbon filter. If you do not have these fans on top of removing the small section as indicated in the MFnano documentation. you will aslo need to remove the ears and top section.See picture above. Flipped the filter orientation: To avoid getting carbon dust and particles in the fan, I decided to flip the filter the orientation. This change ensures that the fan remains protected from any loss carbon debris.Standardized the magnets: I swapped out the 4x6mm magnets with 6x3mm ones, which is a standard used in Voron builds such as Tap. This change ensures compatibility and consistency with other Voron projects.Replaced the logo: I decided to change out the logo on the carbon filter with a Voron logo, customizing it to match the aesthetics of my printer.There is both a multipart logo and a non-multipart part one. For carbon, I use the same lose carbon kits you can get from resellers for the Nevermore Fabreeko, DFH, KB3d etc.. Note: Please see the following warning from the Nevermore projectMPORTANT! Since first release the varying quality carbon out there has become increasingly evident. Users have both gotten bad carbon as well as outright dangerous stuff (in one case oxidizing most metal surfaces in a new voron in minutes. Be sure to vet your carbon supplier! You do not want your printer to look like this.BOM:2x M3x16 BHCS5x M3x6 BHCS16-20x 6x3mm Neodymium Magnets3x M3 Heatset Insert5015 Blower Fan Notes:The 5015 fan needs the ears, top and front removed as pictured.You will most likely need to clean up the tabs that hold the top and bottom half as wellThe Cartridge Body includes a support that needs to be removed as shown in the pic (neon yellow section)