Voron v0.1 DCDC bracket

prusaprinters

This bracket is to be used to mount the DCDC 24V to 5V converter to the bottom of the frame, as in the LDO kit instructions. It is thick enough to withstand the weight of the DCDC converter by using just 2 screws, however you can apply VHB tape on the thinner block and stick it to the bottom ABS panel as well as using the two mounting screws. There is a cable channel under the bracket which can be used to route the bed cables. HW required (extra): 2 pcs M3x16 (should be some left from the kit) 2 pcs 3mm by 6mm or 8mm length plastic thread screw or wood screw with flat tip. Print using standard Voron print settings (0.2mm layer height, 4 perimeters, 5 solid layers, 50% cubic infill). Model made in OpenSCAD. Category: 3D Printer Parts