Voron Stall Door Hinges

prusaprinters

I always dislike dealing with doors that keep flopping in the way. Just like the bathroom stall door, these hinges will hold the door open or closed. These can be used with the double sided tape or drill holes. The holes are far enough from the edge so it should be easier to not crack when drilling them out. With the magnet door latch it would probably be a good fit. If you are trying to do the single door mod this may not be good enough for that since I worked the holding out with the voron 2.4 350 door in mind. Also note these do have the door panel sit flat against the face of the frame.Hardware:M3 x 8mm and tnut (I think its the same hardware used for the original hinges)M3 x 15mm+ longer is fine, I think I have 30mm in mine at the moment. Printing: What ever filament you want, I did these in abs and 20% infill. The part that attaches to the door you could print em as I have them or flip them flat. I did 2 hinges per side and worked fine.