Voron Afterburner ADXL345 Mount

thingiverse

This is a generic ADXL345 mount for the Voron Afterburner toolhead. It uses the two lower hotend fan housing M3 bolt locations to attach the mount and gets the sensor close to the nozzle. To install the chip to the mount use two M2x10 or M2x12 bolts and two M2 nuts. I also used two M2 washers stacked in between the chip and mount to offset the chip to account for my imperfect soldering of the header pins. You can then remove the two M3x12 bolts from the bottom of the toolhead, slide the mount assembly on and attach it using two M3x20 bolts. I recommend doing this after ensuring your toolhead is in position to perform input shaper resonance measuring and will not need any homing or bed leveling operations performed as the sensor will likely crash into the bed. Note: This mount is designed for generic ADXL345 chips with 15mm mounting hole spacing. Please confirm your chip shares these dimensions to ensure compatibility