Voron 2.4 "Wago" 221-415 mount

prusaprinters

<p>When I printed the “wago” mount for my Voron 2.4 build, I found my connectors did not fit the slots on the model. I realized the clips I had were knockoffs and not Wago by brand, however even the measured size of the slots is smaller than what I found on the Wago spec sheet.</p><p>I've uploaded this model in case someone else is dealing with knockoffs made by the same manufacturer, as is frequently the case.</p><p>I attempted to preserve the original design, but increased slot width from 29.35 mm wide to 30.1 mm. The design was also updated for 18.1 mm depth and 9.9 mm height at the rear. For my knockoff wagos, this produced a snap fit without adhesive, but adhesive might still be helpful given the connectors will live upside-down and have mains power on them.</p><p>&nbsp;My print was in ASA and using the Voron printed parts recommendations. I had some heat issues affecting overhangs when I printed this part, but the 45 degree at the bottom is easily handled by most printers.</p>