Voron 2.4 Front Skirt 19mm Power Switch Adapter

cults3d

I found it hard to reach behind my 300mm Voron 2.4 to turn the power on/off, so I looked for a front panel power solution. Whilst there are modified skirts, these take an age to print. I found an insert that allowed the fitting of a low power round switch, but I wanted a mains switch so I created an insert for the common round 19mm mains push switch. The result is an adapter that is easy to print; easy to fit; and prints in about fifteen minutes. The insert will properly fit only in the upper honeycomb holes. Fit the adapter with the slot to the top (follows the curve of the skirt). Remove the rubber seal from the switch before fitting to allow the switch to fit flush to the adapter. Remove the skirt from the printer before installing the switch if it makes it easier to fit and wire up. Note that all my designs have gone through an iterative process to ensure that the item fits accurately and is easy to print. If you like this, please consider my Voron 2.4 adjustable foot design...