Voron 2.4 BLtouch mount

thingiverse

This is a mount for the BLtouch for the Voron 2.4 The standard probe PL-08N2 have a max operating temperature of 70 degree Celcius and will eventually melt when printing ABS. The BLtouch can withstand a higher operating temperature and is more accurate than the inductive probe. Depending on which controller electronics you have, you will have to refer to the documentation on how to wire up the BLtouch. I have added a picture on how to wire up the BLtouch with the Fysetc Spider Board. It's quite simple to change the firmware setting. Change the following in the printer.cfg file, comment all probe settings, and uncomment the BLTouch settings: # Probe ##################################################################### #[probe] ## This probe is not used for Z height, only Quad Gantry Leveling ## In Z+ position ## If your probe is NO instead of NC, change pin to ^!PA3 #pin: ^PA3 #x_offset: 0 #y_offset: 25.0 #z_offset: 0 #speed: 10.0 #samples: 3 #samples_result: median #sample_retract_dist: 3.0 #samples_tolerance: 0.006 #samples_tolerance_retries: 3 ##################################################################### # Bltouch ##################################################################### [bltouch] ## Bltouch - If you use this section , please comment the [probe] section ## More infomation at : https://www.klipper3d.org/BLTouch.html ## This bltouch is not used for Z height, only Quad Gantry Leveling ## In Z+ Position sensor_pin: ^PB14 ## In Y+ Position control_pin: PB13 x_offset: 0 y_offset: 25.0 z_offset: 0 speed: 3.0 samples: 2 #3 samples_result: median sample_retract_dist: 3.0 samples_tolerance: 0.006 samples_tolerance_retries: 3 Print the parts in ABS 0.2mm layer, 4 outlines and 30% infill