Voron 2.4 300x300 panels and removable door

prusaprinters

<p>I got tired of the panelclips on the original 3mm acrylic panels, the foam glided down and the panels was moving towards gantry so it got scraped. Made a printable frame in 16 pieces to acomondate foam and hold the panel tight against the frame. The distance from the extrusions is now 6mm and easier to remove since its one piece. The upside is that the frames eaven insolate the extrusions so heating is faster and more eaven. Its made for 4mm panels so if u have the original panels u can use them with foam on both sides.</p><p>Backpack is made for a 60x60mm bom fan without any filter (i run nevermore so no need for filtering when exhausting air)</p><p>Print settings: 0,2layer, 5top/bottom, 4walls, 40% grid infill, no supports.</p><p>&nbsp;</p><p>Bom</p><p>Side and top panel(for each panel):</p><p>40 heatinserts M3x5x4</p><p>40 M3x8 countersunk</p><p>16 M5x18 Bhcs</p><p>16 M5 rollin T-nut</p><p>5x2mm Foam (around 2meter)</p><p>Superglue to glue the outer frameparts together</p><p>&nbsp;</p><p>Door:</p><p>52 heatinserts M3x5x4</p><p>40 M3x8 countersunk</p><p>16 M5x12 Bhcs</p><p>16 M5 rollin T-nut</p><p>5x2mm Foam (around 2meter)</p><p>10x1mm Foam (around 2meter)</p><p>6 M3x6 shcs</p><p>4 M3x12 shcs</p><p>2 M3x8 shcs</p><p>3 5x39mm pins</p><p>66 6x3 magnets (round 6mm diameter and 3mm height)</p><p>Superglue to glue the outer frameparts together</p><p>&nbsp;</p><p>Backpac(exhaust)(this replaces 1 top middle part from the side frames):</p><p>18 heatinserts M3x5x4</p><p>12 M3x30</p><p>10x1mm Foam to seal between each part</p><p>M10 pneumatic/bowden coupler</p><p>&nbsp;</p>