Voron 0.1 Utility Belt Corner Brackets

prusaprinters

<p>A while ago I printed the Utility Belt. One of the main advantages of the design is the hinge on the back that allows you to raise the tophat. I quickly found that the whole thing would tilt up when I lifted the tophat to access the print bed.&nbsp;<br><br>My solution was to add some brackets to the front corners that tie into the top rails. This holds the Utility Belt down when the Tophat is raised.<br><br>The parts are easy to print (upside down) and use two of the nuts that you would have inserted if you followed the original instructions before fitting the utility belt.<br><br>Printed:<br>4 wall<br>0.2 layer<br>5 top/bottom layers<br>ABS<br>40% infill<br><br>M3x8 BCHS<br>preloaded M3 nut</p>