Voron 0.1 Temperature Display

prusaprinters

<p>If you're printing ABS it helps to know the temperature inside your enclosure so you're sure its 'heat soaked' enough and your print isn't going to peel off the bed.</p><p>The front skirt of the Voron 0.1 has been modified to hold a digital display so you can clearly see the temperature inside the enclosure.</p><p>The cable to the sensor is routed under the printer, up inside the back of the enclosure and attached with an M3 bolt and nut.</p><p>The temperature sensor has a mount which you attach at the same level as the hotend. This will give an accurate indication of the enclosure temperature for the first layers of the print. &nbsp;Important for printing ABS, Nylon and other difficult plastics.</p><p>Full instructions can been seen on YouTube.</p><figure class="media"><oembed url="https://youtu.be/OTidzpCcqKU"></oembed></figure><p>STLs for the skirt, display holder and sensor holder are below.</p><p>Ideally print the sensor holder in ABS as its inside the enclosure where it'll be toasty.</p><p>0.2mm layer height, no supports.</p>