Volvo V50 cup holder

thingiverse

I was motivated to create it, because I had enough of cleaning my car after spilled coffee ;-) It fits to Volvo V50 after lifting [2007-2012]. I'm not sure if it will fit for S40. Inside you will find [no_supports]V50_cup_holder_main_V3.stl - just slice it as it is without support - this set needs to be glued after printing. I've used 2-ingredients glue based on resin and it works well - I do not recommend acrylic glue if you are using PETG. Please note that holder will be used in quite warm environment, so it is recommended to use at least PETG - PLA material may deform during hot summer or after put hot coffe. If you want to have everything connected after printing, use [complete_set]V50_cup_holder_main_V3.stl - then you'll need to use supports. There are also stls with separate parts - you can do anything you want to with those :-) Enjoy you coffee :-) V4: I created new version with extended brackets for cups; rear + 10mm, front + 25 mm and additionaly I've changed diameter of bottom hole to 50 mm - now smaller cans will fit (if someone wish to have it closed, there is a special adapter). I also lowered top part a little bit since I noticed that slider rubs on it during moving. 3-parted no support version (glueing needed) V5: Version with fully filled brackets - print it in vertical position with supports only from bed. You will need slow down printing speed since there are some arcs on the top.