Volkswagen Rabbit Caddy Pickup MK1 Headlight Adjusters

thingiverse

Designed these for a friend to save the $40+ that places charge for a set of new ones. They fit and work great on his 1982 VW rabbit pickup and will likely fit other MK1's as well. I only printed them using PLA which I'm sure will deform over time and would suggest PETG or ABS for longer term use. Designed to be installed with 1/8" pop rivets. We used 1/4-28 nuts because they fit the studs perfectly, but being that this is a Volkswagen I believe they should actually be M6x.75. The plugs go in after the nut is "pressed" in and held in with a drop of super glue. Supports are needed under the offset one. The spot at the top of the hex area bridges fine without supports, but requires a little cleanup after printing. Hope this helps people with the same issue as my buddy. Feel free to modify the design as you see fit.