Volantex Phoenix S Matek F411 Wing holder

thingiverse

I wanted to install a Matek F411 Wing FCC on my Volantex Phoenix S, so I created these three parts for that purpose. 1) small plate to bolt the F411 Wing FCC onto - You'll need slightly longer screws to bolt it on or don't use the bottom plate that comes with the F411 Wing. Alternatively, use some velcro, tape, or tie-wrap to hold it in place. 2) battery plate - Remove the wooden tray that comes with the Volantex. Use this battery plate instead. You'll need to retain four screws of the wooden plate to keep this new plate in place. You won't need to use the front screw holes in the fuselage. 3) supports to place between battery plate and F411 plate - Print two of these. Use CA glue to glue the support in place between the battery and F411 plate. Bear in mind that the F411 bolt holes are not in the middle of the plate. One end is longer than the other. Check before gluing in place. Glue these parts together, then put the F411 in there. Screw it into the fuselage and you're good to go. I use this with a 3S battery and Caddx mini FPV cam on the tail. Balances perfectly.