Vittorazi throttle starter button add on

thingiverse

Fits onto bottom of V throttle with space for two switches to be used to trigger starter. Made for 10mm switch. Just search Metal Push Button Switch 10mm and find the same ones. Wires run up from switch compartment through a hole to under throttle (there's space), then under the rubber boot of the throttle cable. You need to notch the metal under the boot to make space for the wires in the same way it's notched on top for the kill switch wires. Either snake the wires through the original loom (hard) or re-loom with 3/8th over top (chance to loom in gauge this way too) Once printed, fit onto throttle, it should be very close fitting. However take the extra step to heat the top half of the print in water to it's glass transition temperature, replace onto throttle and use pressure mold the upper half to the throttle for a zero clearance fit. Part should retain itself fairly securely through friction, but use a secondary fixing as well. I used double sided tape on the bottom of the throttle. Bottom plate is designed to be glued in place for simplicity, destructive removal is expected if/when necessary. (just reprint)