Vital Bracelet 6 Slot DIM Card Holder with Lid

thingiverse

The original design was a great design, but I needed to make a few tweaks: 1. The lid was way too tight after printing, to the point where it felt like I was going to snap it when opening and closing, so I made it 1mm wider. 2. I didn't need anywhere near that many dim slots, so I shrunk it to 6. 3. I didn't particularly like printing the lid and base at the same time, so I split up the model to allow for more control over print orientation. Cura believed the original needed supports all the way around, so I always printed it (and this remix) with "Make Printable" enabled and set to 50 degrees. You may or may not need this.