Visera covid elevable UCI Larga

thingiverse

I created the shortened version at the request of people as Cura 4.5 and 4.6 do not allow printing the long and shortened versions on the Ender 3, but Cura 4.4 does. This is ready for horizontal expansion 0. Unlike other visors we have tested, this one can be raised. It has a system of walls that are 2 mm thick and holds up well over time. There are grips on the top of the head and a trigger system that allows the 0.75mm PVC to rise. To lower it, you must press both COVID logos on the sides at the same time. It has an emergency stop to prevent the visor from falling too far if the trigger fails. There are six different models: S visor with 15 mm height, M visor with 30 mm height, and UCI visor with 40 mm height offering more protection. There are two formats: long, more ergonomic, and short, easier to print. A 10mm rubber back is also needed. Covidmakers@protonmail.com is the email of Camp de Morvedre's organization and can be contacted for orders or new prototype designs. This design is a donation to the cause and cannot be sold.