Visera covid elevable M corta

thingiverse

Due to public requests, I've created the short version since Cura 4.5 and 4.6 do not allow printing the long or shortened versions on an Ender 3, but Cura 4.4 does permit it. This model is prepared for horizontal expansion 0. Unlike other visors we have tested, this one can be lifted up. Made to last with its 2 mm walls, it has handles at the top of the head and a toggle system that allows raising the 0.75mm PVC, which can only be lowered by pressing both COVID logos on the sides simultaneously. It comes equipped with an emergency stopper so the visor cannot go below the allowed limit if the toggle fails. There are six different models available: S Visor with a height of 15 mm, M Visor at 30 mm, and UCI Visor at 40 mm for maximum protection. There are two formats: long and more ergonomic, or short and easier to print. Additionally, a 10mm rear gasket is required. Covidmakers@protonmail.com is the email address of Camp de Morvedre's organization, where you can contact them for orders or new prototype designs. This design is donated to the cause, prohibited from being sold.