Vis Diam. 5mm long 25mm Thread Step 0.8 Diam Ext 4.9

thingiverse

Customized Version of Bolt Head - Counter-Sink Created with Customizer! Instructions Using the Options Below: - Head Type: Countersunk - Nut Resolution: 0.5 Units - Thread Step Size: 0.8 Degrees - Outer Diameter: 9mm - Inner Step Shape Degrees: 45 Degrees - Slot Depth: 2.5cm - Bolt Type: Fastener With Flat End - Outer Diameter of the Object: 14inches - Drive Type: Internal Recessed Area - Nut Style: Normal (Straight Side) - Head Diameter at its Largest Part: 10cm - Width of Groove in Slotted Hole: 1.5 inches - Thickness or Distance Between Parallel Places: 2mm - Diameter of Nut Across the Flats: 12 inches - Resolution in Creating 3D Objects (Unit Measure): 0.25cm - Nut Internal Angle Shape Degrees: 45 Degrees - Hole Size Used for Driving Tool Attachment Point: 5 millimeters - Inside Hole's Largest Part Diameter: 8.2mm - Surface Finish Applied on All Parts Including Faces and Edges: Faceted with a Smoothing Process - Low Level, to Allow Good Adhesion and Better Durability of Coatings. - Remove Pattern on Any Side for an Even Look - Use No Patterns to Show Clean and Plain Object. - Size Height (or Height in General Terms): 5 units (height). - Head Length at Center When Compared from One End to Another is Considered As: Wings ratio = length/2 of wing. - Diameter Across Top, or Height on Flats Where Screw Meets a Part (Head), when Considering its Dimensions and Features as Separate: height on flat head = nut height above flat part where thread begins