Virpil CM3 detent for CosmoSim/SWS

prusaprinters

This is a detent for the Virpil VPC MongoosT-50CM3 Throttle made for Star Wars Squadrons (SWS). In Squadrons you spend a lot of time going from full throttle to zero throttle (and a few times in the middle) very rapidly and almost constantly. This throttle has a LONG rang of motion that while brilliant for precision flying, makes for a lot of rowing in SWS. This detent reduces the arc of travel to~40 degrees and includes a center notch for that maneuverability sweat spot. Two versions provided here. Both with more or less the same geometry, but one has an over hang that captures the detent roller from lifting. Due to the geometry of the detent lifters if you push too hard you can overdrive the detent. The one with overhang prevents that. Notice: be sure to update your throttle's calibration range with the detent installed in the Virpil software. Otherwise you will never be able to get to 0% or 100% throttle. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: Yes Resolution: .200 Infill: 20% gyroid Filament: eSun PETG Black Notes: Prints best on it side with supports from the bed only. Can be printed without supports but the alignment notch may not be clean enough for a nice clean fit. Category: Video Games