Viomi V3 Zubehör Ständer

thingiverse

This project involves creating a stand for storing various accessories of the Viomi v3 from Xiaomi. Given that predecessor models such as Viaomi v2 and v2pro use similar or identical accessories, it's possible that this stand may be suitable for these models as well. The stand is modular in design to optimize the pressure position for each part. Individual components are assembled together after printing, and if necessary, glued. However, with precise measurement of the prints, it should hold together without gluing. I would still glue the handle, though, if you plan on carrying a fully loaded stand. It's quite heavy with two containers (possibly even filled) and a mop. Here are the components: - The lower part is the base of the stand. Two arms are inserted into this part. It can be printed in its normal position - Arms to the right and left hold the containers and complete holder for the mop. They're essentially the link between the entire structure. These parts should be printed with their outer side facing down. The print bed should be approximately 300mm large to fit. - Holder for the mop tines on the right and left are connected to the respective tine. Although they look almost identical, they're actually mirror images of each other. They're printed lying flat on their underside. - Tines on the right and left are inserted into the holder until they snap in place. They look similar but are again mirror images of each other. In any case, the middle beam where the mop rests must be mounted with its thicker side facing outward, as the edge where the mop lies is slightly angled. It should be printed flat on its outer side. - The beam is needed twice and stabilizes the arms in the middle section. It should be glued to the ends of the arms. These parts are printed standing upright. A brim must be used here to prevent them from toppling over during printing. - The handle comes last, sitting on top of the arms, serves as a visual conclusion, and provides an opportunity to quickly move the stand to another location. It should be glued in any case if it's intended for carrying. It's printed in its final position, with the curve facing upwards. One more note: try to keep the 550ml water tank in the lower compartment. This part is quite heavy, especially when filled with water.