Vigorun smart body scale F60E-BT foot

thingiverse

I broken the feet of the Vigorun Smart Body Composition Scale model F60E-BT making it unusable. As the parts are not available for replacement, I decided to draw my own using Fusion 360 (I'm not so skilled but I'm learning!). They fit very well. Just remove the small metal disk and the rubber disk from the original foot and put them back in the printed one. For the metal disk I suggest the use of a small hammer to push it all the way down in its seat. No glue is needed (unless you break the rubber disk adhesive, where a double sided tape would be the best choice). I printed them in PLA with supports and using a 0.2 layer height. I suggest to replace all 4 of them to be sure they are all the same (my drawing may differ a little bit from the original one).