Victualling Inshore Craft VIC Add-Ons

thingiverse

These are all addons to my version of VIC 96, I have gone through hundreds of pictures of the real boat and tried to recreate as best I can. I will add more as I go. **Information about what the differences there are on the different parts below:** **Bridge_2dr_Thicker:** Made the inner walls from 2mm to 4mm. Easier to remove the needed supports without breaking it. **Bridge_2dr:** The original ship has two doors located in the back of the bridge. Added these. **Bridge_1dr:** I was unsure if i wanted two or one doors on my model. Made both. **Anchor_chain_link:** Links that are design to print piecemeal and then assembled to the right length. **Cargocover_Cutable:** The cover was too big for my printbed, added an edge in the middle for better adhesion when glued togheter. Just cut in the middle in your slicer and print. **hull_pt2** Made a hole on this hull part to mark where the mast would be placed. The hole is 2mm, depending on what screw size or how you would like to mount the mast, this might need some drilling. **Winsch_A & B** A very simple version of the mast. I took unused 1.75mm filament for the joints and rope from a curtain, and voilá it moves. They are easier to print if you cut them into pieces and glue them togheter after. **Superstruckture** I made a hole on top where the bridge will be, its a floor the bridge so its just a waste of filament. I also deletet one window because after looking at picture of the original boat the dont exist. I also raised the wall in the back, it to tight fit on the frame. (Atleast on my build.) **Watertight_Door** This is not my design form start. It belongs to Denko66. Thank you! I just modified it a little bit to get more area to glue on.