Vibe Sea Ghost 110 Fish Finder Transom Bracket

prusaprinters

<p>I got a new Vibe Sea Ghost 110 kayak and a Humminbird Helix 5 fish finder, and in going through the process of modifying, customizing, and setting up my kayak, I got very upset with finding out I would have to repeatedly spend upwards of $20-$50 for the next piece of plastic I would need.</p> <p>In this case it was to attach my Humminbird Helix 5 fish finder transom mounted transducer. So I came up with a bracket design that would work and printed it for around $2 in material. This would likely work for other finders on the Vibe Sea Ghosts as well.</p> <p>Even though the bracket has the screw holes to match a perfect layout on the Vibe kayaks, my kayak itself was actually a little off of perfect. One of the pre-drilled holes in the hull is a little off kilter, so I had to widen one of the the bracket holes a bit post-print. However since that is the kayak's fault and not the bracket, I am leaving the design as accurate. Use M5 stainless steel bolts to put it in place.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Dremel Digilab</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>3D20</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div> <p><strong>Filament:</strong> PLA PLA Green</p> </p></p></p> Category: Sport & Outdoors