VGA Holder v1.6

thingiverse

Creation of this holder was inspired by the DeepCool GH-01 A-RGB model. My main task was to design a model without fixed support heights, with height adjustment that would be smooth in any position. The second task was to create a device without metal screws and latches, one that could be quickly and easily assembled and disassembled. This holder consists of four parts: 1. Main stand 2. Front panel 3. Fixing screw (one per Support) 4. Support (one or two in the device) There are two options for the Main stand: with holes for ARGB LEDs, and without holes. There are also two options for Support: with a hole for tightening (ziptie) the power cable of the video card, and without a hole. During assembly, the Front panel is attracted to the Main stand with the Support and the Fixing screw. This mount can be strengthened by connecting the Front panel and the Main stand with hot glue or double-sided tape. Mounting ARGB LEDs tapes must be done on two inner planes of the front panel. The best effect is obtained when using tapes with more than 100 LEDs per meter. As a light diffuser, you can use paper, white electrical tape, or hot glue (for ABS and PETG), neatly applied inside the holes of the Main stand. It will not be superfluous to mount rubber or silicone pads on the lower plane of the Main stand and on the Support. I strongly recommend that parts containing screw threads be printed with at least 25-30% infill and a layer of not more than 0.1 mm. All parts can be printed with any plastic (PLA, ABS, PETG). The best results can be obtained by using PETG. Sorry for my English. This is not my native language.