VFC Carl Gustaf TAGINN Firing Pin

thingiverse

The stock firing pin on the VFC Carl Gustaf 84mm shells is too short and has too little travel to trigger TAGINN airsoft 40mm shells. This replacement firing pin is beefed up to allow it to trigger TAGINN shells. Installation is pretty simple, you only need to remove the crosspin that holds the stock firing pin in, then you can remove the old firing pin, place the new one in the slot, and replace the crosspin. Bear in mind that TAGINNs require a significantly longer firing pin to trigger, so this firing pin may actually be /too/ long for certain 40mm grenades. NOTE: Depending on the tolerances of your printer, you may need to shave down the area of the firing pin that makes contact with the 84mm shell's firing pin to make the 84mm shell baseplates easier to rotate.