VexIQ Motor to LEGO Technic Axle Converter 01

thingiverse

Stubby VexIQ Motor (square shaft) attaches directly to LEGO Technic Axle (cross-shaped). This print requires extra attention: even on high-end printers like the MakerBot Method, a small amount of sanding is necessary to remove excess material at the base. A raft is almost certainly required for this version, which prints without supports. The axle fits snugly onto Method prints; you may need to adjust its size slightly to match your printer's accuracy - the square shaft can be sanded down, but the cross-shaped insert cannot be modified, so ensure it matches your print exactly and sand the VexIQ side as needed. Check out this converter in action: https://youtu.be/zAYUtxhk-GM Next up, we're working on a servo version because our LEGO Forma is going to connect directly to the internet!