VEX EDR 60 Degree C-Channel Bracket

thingiverse

This is a bracket used to connect 2 pieces of VEX EDR c-channel (2-wide) at a 60 degree angle. Use 3 brackets and 3 equal-length c-channels to construct an equilateral triangle. I've included a basic version and one with a reinforcement spanning the joint. I've Printed them at 0.2 mm layer height in the orientation shown with no support (The overhangs should be small enough for most printers) If strength and layer delamination are an issue, then I'd recommend printing them on their side (with "support everywhere") so that the 60-degree angle is flat on the bed.