Vespa and Stella Gear Oil Funnel

thingiverse

Refilling Gear Oil Funnel for Vespa and Genuine Stella Motorcycles Are you looking for a hassle-free way to replenish your gear oil on your Vespa (compatible with P series, T5) or Genuine Stella (at least the 2t model)? Look no further! This funnel is specifically designed to fit your vehicle's gear oil hole. The unique design of this funnel allows it to stand upright without any support, making it easy to use even when your hands are occupied with other tasks. However, it may take a bit longer to drain the thicker gear oil from your tank. To minimize any potential issues, simply sand or cut off a small amount of excess PLA material where the spout meets the oil hole. Assembly Instructions: Load the Makerbot with this 3D-printed funnel. Trim approximately half an inch (or 1 cm) of unwanted PLA from where the spout inserts into the gear oil reservoir to ensure a snug fit. Gradually fill the oil compartment, allowing the liquid to flow freely. Repeat the process until the compartment is full and your gear oil level meets the manufacturer's recommendations. With this handy funnel, you can easily top off your gear oil without making a mess or compromising its performance. Try it out today and enjoy the convenience of hassle-free refilling!