VESA monitor stand with LED

thingiverse

This is a VESA-compatible stand that comes with LED lights. It incorporates a 4-bar linkage design for the tilt mechanism that can support monitors of most weights and sizes. video: https://www.youtube.com/watch?v=e_uDp94d_GY Maximum weight: watch the video to find out Maximum height 11 in (though you can just scale the z height and make it taller) Can be used for portrait mode if your monitor is 23 in or smaller. (Less than 21 inches in width) Tilt about +- 5 degrees Angle +- 40 degrees safe loading: 20lb The stand is part of a bigger monitor arm project that I started in the summer of 2021. My goal is to 3D print a fully functional ergonomic monitor arm. If you want to follow along, make sure to subscribe to my YouTube channel and check out other builds. Print settings: We used PLA in testing but I would recommend using ABS or ASA especially if the ambient temperature in your environment is above 25C. This is highly important because PLA will creep and deform over time if the room temperature is too warm or the load is too high. 15-18 % gyroid infill 4 Walls 0.15 layer height Support as needed Orientation is highly important to see one of the images. Parts list: 4 ¼ in screw 3 in length ¼ in screw 3.5 in length 5/16 in tapered screw 1.5 in 20 ¼ in washers 2 5/16 washers (one 1.5in diameter and one regular) ½ in threaded rod 14 in 2 ½ nylon locknuts 5 ¼ in nylon lock nuts 2 ½ in washers 1 kg roll of filament 4 days of print time