VESA/Monitor Offset Mount

thingiverse

Solution: A mount plate shifts your 100mm VESA-mount monitors by 40mm to perfection. Problem: Three monitor/arm stand purchases left me with arms that weren't quite long enough for my monitors. This mount plate solves the issue by offsetting the side monitors by 40mm, preventing bevel edges from overlapping. Designed in OpenJSCAD, I included the source code so you can tweak it to suit your needs. The 100mm VESA spacing and 40mm offset are variables that can be adjusted along with a few others. Two prints of this mount plate have supported my two 27" monitors for several weeks without issue. If yours collapses, don't blame me - I've tested it thoroughly. My first test print had fewer layers and infill than my second, but both are holding up well so far. I recommend using washers when mounting the plate, even though the ribbing can be a bit of a nuisance. My second monitor has a stronger print, and I didn't use washers there - no signs of degradation after about three weeks.