Very Compact Foldable Pasta Dryer

cults3d

ENGLISH Hi There, As my children offered me a pasta machine, i wanted to buy a pasta dryer. All the models i saw were foldable, but when not used, they take a lot of place because the sticks stay in place. So i draw this model, where all the sticks fit in the central axis, so when stocked, this pasta dryer is really compact. Sticks are made with 9x8 aluminium tube You will ned to print: 1x Foot 1x Bottom pin 1x High axle 1x Tube holder 1 8x Tube holder 2 9 1x Tube holder 10 1x Cap with logo 1x Logo insert 13x Aluminium tube cap You will need to cut: 13 parts of 9x8 Alu tube, 215mm long. ASSEMBLY: Glue together the part called "Pied" with "Axe bas", and this ensemble with "Axe haut". Glue the logo insert in "Plug with Logo". If you are like me, and prefer non shinny flat surfaces, you can sand the top of this tap, it have a good render. Depending the resolution of your printer, may be you'll have to sand a little bit before glueing. You don't know how to sand easily ?: have a look and consider this wet sanding machine i published a few months ago : https://www.thingiverse.com/thing:3969508 Insert the 13 caps at one end of the tubes. Insert the 10 tubes in "Porte Tube", indifferently, cap visible. You've seen you have 3 models of "Porte Tube", N°1 is the first to be inserted on axis, N°2 to N°9, are following, N°10 will be the last one, Insert the 3 last tubes in "Pied", Add the upper axis cap, And Voilà!!! Make a lot of delicious fresh pastas and let them dry!!! Enjoy. ENGLISH: Hi, Since my kids got me a pasta machine, I wanted to buy a pasta dryer. All the models I saw were collapsible, but when not in use, they take up a lot of space because the rods that hold the pasta stay in place. I drew this model, where all the supports fit in the central axis, so when stored, this pasta dryer is really compact. The stands and tripod are made of 9x8 aluminum tube You will need to print: 1x Foot 1x Low axe 1x Axe high 1x Tube holder 1 8x Tube holder 2 9 1x Tube holder 10 1x Cap with logo 1x Insert logo 13x Aluminium tube cap You will have to cut: 13 pieces of 9x8 Alu tube, 215 mm long. ASSEMBLY: Glue together the part labeled "Foot" with "Bottom Axis", and this assembly with "Top Axis". Stick the logo insert in "Cap with Logo". If you're like me and prefer flat non-glossy surfaces, you can sand the top of this cap, it looks good. Depending on the resolution of your printer, you may need to sand a bit before gluing. Can't sand easily? Check out this wet sander I posted a few months ago: https://www.thingiverse.com/thing:3969508 Insert the 13 plugs at one end of the tubes. Insert the 10 tubes into "Tube Holder", indifferently, cap visible. You have seen that you have 3 models of "Tube Holder", No. 1 is the first to be inserted on the axis, No. 2 to No. 9, follow, No. 10 will be the last, Insert the last 3 tubes into "Foot", Add the cap for the top axis, And voilà!!! Make lots of delicious fresh pasta and let it dry!!!