Verticle Mount Feet for Mean Well SE-450-24 (and other similar p/s with the same hole pattern)

thingiverse

UPDATED: New files for more even leg length, added indicator for longer side screw distance (triangle). (see cover for Se-450-24: https://www.thingiverse.com/thing:2556126) I upgraded my Taz power supply with a Mean Well SE-450-24. The venting side of the power supply has large holes that allow small screws or other objects to easily enter, so I prefer to stand the power supply vertically and direct the fan away from my printer bed (to avoid ABS's added draft). To make it more stable when standing vertically, I added stabilizing stands/feet. There are two different designs required; one to miss the end cover and one for the opposite side. The ones shown here are done in PLA to match the cover. You will need four M4X16mm long cap screws and washers (available at Home Depot), I used hex head M4x16mm screws and made a slot in the head with a hacksaw so I could use a flat blade screwdriver. The M4 washers I used are about .5mm thick and less than 5.5mm in outside diameter. This design should work for most power supplies that are 50mm tall and have four inserts on the side that are 25mm apart. Note that the insert closest to the side with no vent holes should be 13.3mm from the side, whereas the one on top is 12.3 mm from the vented side. If you have trouble getting the screws started try flipping the stands 180 degrees, or measure first to determine which insert is farther from the edge. Note: The side with the longer screw distance has a triangle on the foot. I added some small strips of rubber drawer liner, which reduces noise and adds friction so it won't slide. I used Elmer's High Strength glue stick to attach the liner pieces.