Vertical Fan Duct Universal Rear Electronics Case for Ender 3

cults3d

I was halfway through crafting my own SKR v1.3 enclosure when I spotted Michael with Teaching Tech's impressive "Ender 3 All-in-one, Universal, Rear Mounted Electronics Case". It had everything I needed and desired in a case - Raspberry Pi, Buck Board, SKR v1.3, and a compact design. For my setup, there was one minor setback. My Ender 3 sits on a foam pad to minimize vibration and noise. The fan exhaust blew directly down into the foam pad, resulting in poor airflow. I didn't want to redesign the entire case, so I noticed there was just enough space to angle the fan at 23 degrees and blow air out the bottom and the back. So after a few modifications in Tinkercad, I carved out sufficient room for the new exhaust on the left side and added a few matching intake vents on the right side as well. The remaining components, the covers, are available in the original project below. I hope Michael doesn't mind; he did an outstanding job designing this case. https://www.thingiverse.com/thing:3688967