Vertical Case for RuiDeng RD6006

prusaprinters

This is a vertical case for RuiDeng RD6006 lab bench power supply. It is designed to fit a power supply unit that comes with RD6006 from official AliExpress store (216 x 114 x 50 mm). You will need some other hardware, which you can find in your local electronics shop: Power socket with fuse (same as comes with kit from AliExpress); Wires and connectors (you may solder wires or use crimping connections); [Optional] Power switch; [Optional] Screws for power supply unit and a back door; [Optional] Thermal glue or just instant adhesive. Uploaded model in different file formats. Print instructionsRafts: No Supports: Yes Resolution: 0.3 Infill: 30% Filament: PETG Black Printed with front face on print bed. It fits Prusa MK3 bed. Supports from print bed are needed to support ident for RD6006 unit. And you may want supports from model to support beams on back side. Assembly Cut all wires to approximate length. Prepare (solder or crimping connectors) one end of ALL wires that will go into power supply unit. That includes 3 input mains wires, as well as 2 output DC wires. Attach ALL wires to power supply unit. Slide power supply unit, while routing wires through the top. You may cut side "fence" of the power supply unit for easier routing. If you are using thinner wires - you can route them through holes in side "fence". [Optional] Once power unit is installed - fix it with screws to the case. This is optional, because the fir should be tight. It is secure even without screws. Insert RD6006 unit, power switch, and power connector. Secure power connector with screws. Optionally you may fix power switch with glue if it is too lose. Cut all wires to final length and connect everything that remains. Attach a thermal sensor. You may glue it to the RD6006's heatsink, or you may route it outside from hole in right side or front side. Install battery and WiFi module. Close back door and fix it with screw.