Vertex k8400 Hood enclosure (Remix)
thingiverse
This is a reworked design inspired by Emil Hallgren's Hood enclosure. To avoid using screws on the frame, I modified it to accommodate my PI holder on the right-hand side of the printer. A lid has been added, along with hinges and a handle bar. The top brackets are glued onto the 4mm Acrylic, forming a frame. The bottom brackets are attached in the same manner as Emil's design. The acrylic sheet measures 22cm in height. You may need to adjust the width to fit your printer; my machine is 38.5cm wide, with 38cm on top and 37.7cm on the bottom. The lid measures 36.5x36.5cm. A 12mm cutout has been made at the bottom of the back acrylic sheet, 9.7cm in from both sides. Print Settings Printer: Velleman Vertex k8400 Rafts: No Supports: Yes Resolution: 0.21mm Infill: 30% Notes: Minor supports were used. It's likely possible to print them without support, however.
With this file you will be able to print Vertex k8400 Hood enclosure (Remix) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Vertex k8400 Hood enclosure (Remix).