Versacopter GoPro Session and Boardcam mount

thingiverse

This mount enables a GoPro Session and a 32mm board camera to be mounted side by side on the front of a Flite Test Versacopter V2 (though not tested on a V1). To secure the mount to the top plate, four M3x8 or M3x10 screws and nuts are required. A narrow velcro strap is necessary to restrain the GoPro from above, along with a small layer of foam between the camera and mount to tension the camera against the velcro. For mounting the board cam (28mm mounting hole spacing for a 32mm cam), you will need four M2x6 screws if threading into the mount or longer screws if using nuts. The print has been tested without issue, utilizing 6-inch props, which results in a small amount of prop being visible in frame in each cam due to their proximity to the edges of the top plate. Although not crash-tested, there are no reservations about its strength. Pictures show the mount minus my VTX and antenna as I am reworking the VTX mount. The VTX and XT-60 mounts can be found here: http://www.thingiverse.com/thing:1664052. The skidplate is from this source: http://www.thingiverse.com/thing:1381484. Print Settings Printer Brand Printrbot Printer Simple Black Rafts Doesn't Matter Supports Yes Resolution 0.1mm Infill 20% Notes With the listed settings and PLA, my print weighs 30g. Slic3r generated one support.