Verlängerungsfüße_Chiron

thingiverse

Drucker = Chiron Base setup for .stl file with TPU filament: left_front_hr.stl = left front and right back right_front_hl.stl = right front and left back Temperature settings: Hotend temperature 210° Hotbed temperature 40° Layer height 0.2 mm Upper solid layer 6 Middle layers 3 Lower solid layer 6 Contour outline layers 2 Contour direction from inside to outside Brims layers 2 Brims offset 4 mm Brims contours 2 Infill percentage 15% Contour overlap 15% Infill extrusion width 100% Minimum infill length 5.00 mm Support material none Standard print speed 1800.0 mm/Min Contour speed 50% Infill speed 80% Layer settings are included in .gcode file vl_hr = left front and right back vr_hl = right front and left back sw = black ge = yellow Measurements in millimeters left_front_hr_sw_1 print start at 0.00 mm, print stop at 13.4 mm left_front_hr_ge_2 print start at 13.4 mm, print stop at 16.8 mm left_front_hr_sw_3 print start at 16.8 mm, print stop at 21.4 mm left_front_hr_ge_4 print start at 21.4 mm, print stop at 25.0 mm left_front_hr_sw_5 print start at 25.0 mm, print stop at 29.4 mm left_front_hr_ge_6 print start at 29.4 mm, print stop at 33.0 mm left_front_hr_sw_7 print start at 33.0 mm, print stop at turn off right_front_hl_sw_1 print start at 0.00 mm, print stop at 13.4 mm right_front_hl_ge_2 print start at 13.4 mm, print stop at 16.8 mm right_front_hl_sw_3 print start at 16.8 mm, print stop at 21.4 mm right_front_hl_ge_4 print start at 21.4 mm, print stop at 25.0 mm right_front_hl_sw_5 print start at 25.0 mm, print stop at 29.4 mm right_front_hl_ge_6 print start at 29.4 mm, print stop at 33.0 mm right_front_hl_sw_7 print start at 33.0 mm, print stop at turn off