Vented ultrasonic cleaner handle

prusaprinters

When rebuilding my blown up 6L ultrasonic cleaner I found that it's cooling is just bad! The box just keeps the warm air inside, causing the driver to overheat and blow up.So I designed these little wents that replace the original handles. Don't worry they also work as handles while protecting the holes from any spilled liquid from above.As for printing you will need supports because of the alignment profile poking from underneath. I personally used combination of raft and support just to give the supports enough space underneath the mesh.Make sure to print these from material that can survive the heat of the cleaner. I personally used the Prusament PC-CF, but if you use your cleaner on the colder side PETG is good enough.