Velleman 1.75mm Spool Clip

prusaprinters

<p>A spool clip for 1.75mm Velleman filament spools. It is 10mm thick by default, but you can scale the Z dimension to change this</p> <h3>Instructions</h3> <p>Print these at 0.2mm layer height. Use a low infill, if any, as this will keep them flexible enough to snap over the lip of the spool. Because these are so small, you can print several at once without increasing the overall print time by much. I printed four of these in about fifteen minutes, whereas one would take about ten minutes to print.</p> Category: 3D Printer Accessories