Vat clean ring pull for resin printers - supportless

thingiverse

Simple ring-pull for use with your resin printer. Push the toe of the boot into the corner of the vat with resin in it. Hold down against the fep gently while you run your vat clean. Tilt away from the corner once the cycle has finished, and the corner of the cured resin should pull up, then you just peel the whole thing out. I printed mine on FDM in the orientation of the file, so the minor ridges in the layers give the bottom of the boot foot a little bit of teeth, and the ring is nice and strong. Of course, after using it once, boot sole was full of cured resin and smooth. But still works! I've used the same one about 10 times over the last year. I just peel off the cured sheet, snap off any bits around the boot, and wipe with paper towel, ready to go again.