Vash Trigun Stampede gun

thingiverse

Here is design for Vash the Stampede new gun. This is close to design I could get in time frame to work with this and going off like 3 images. Should be good enough for anyone to use for cosplay. Made a few changes after doing test print but overall the test print came out fine. Print should be little over 16 inch when done. Test print was done on Elegoo Saturn 2. Did use hollow for each piece beside peg. 2mm wall thickness was used for test print but may be thin if you plan to be rough with it. Recommend 4mm wall thickness, 0% precision, and infill 10%. Hope you all enjoy. Fixed Trigger Guard file - Had extra plane in background that didn't get deleted. Also Side note Trigger Guard and Cylinder parts both have a empty circle spot. This is there to add magnet to hold in place and not have gun swing on peg. This will depend on magnet strength if it helpful. UPDATED NOTES: Due to several request and more reference for gun I have made a few changes to design. If you see the words updated beside files these will include some changes. Must use all updated parts together can't change or mix and match some older parts. Following changes have been made: 1. Grip redesign to look more like model. 2. Hammer modified to look more like model 3. Trigger Guard change for more finger space and longer trigger. Part of the iron sight up top now allow magnet to be put in place. 4.Iron sight is been converted to peg system to allow iron sight to swing up like in the anime. also include space inside for magnet. This should allow in theory to hold gun from swing upon more. 5. Trigger modify to be longer and gave more space in trigger guard for better support. 6. Rear part of barrel had parts adjusted to better mirror both side of the model. Few request unable to complete at this time and may not get to. Some of them include Trigger and Hammer being functional. 4/7 update: made a few minor changes based on feedback 1. Made cylinder smaller for updated version. (Cylinder was getting caught on top of updated trigger guard) 2. fixed updated grip to be a little smoother towards the top.(feedback suggesting it to be too much curve digging in hand) 4/8 Update: files replaced from 4/7 due to certain modifiers not applying. 4/10 Update: Ironsight part 1 updated was not sitting correctly on Trigger guard assembly. Modify file for better fit. part is now called Ironsight part 1 fixed